Installing a replacement piece of vinyl siding is the reverse of removing the damaged panel.
How do i remove a piece of vinyl siding.
Look for a horizontal seam between two courses of vinyl siding.
Hold the loose undamaged piece of vinyl up and out of the way with one hand.
Working in one direction unzip.
Reveal the nails anchoring a piece to the wall by sticking the zip tool under the bottom of the piece above it.
Go to the end of that row either near a corner piece or a j channel.
Once the zip tool is latched onto the lip pull the siding piece downward and slide the tool horizontally across the entire length of the panel unhooking the lip.
How to remove and replace a section of vinyl siding.
Insert the tip of the zip tool into the.
Look under the siding piece you just located for a short flat notch.
Insert the siding removal tool where the panels overlap and pull down and out.
With the other use the claw end of a hammer to pry up the nails holding the damaged piece of vinyl to the wall.
Slide the zip tool along the bottom edge to release the vinyl siding from the piece below it.
Use a cat s paw or other small pry bar to pull the nails from the course you need to remove.
Remove the nails one at a time to disconnect the entire length of vinyl.
Use a zip tool to disconnect two pieces of siding.
Repeat until you re at the ground and then remove the surrounding trim.
To remove a piece at your eye level slide the zip tool under the piece above that one.
Locate the vinyl siding piece above the piece you need to replace.
Start by lifting an overlapped piece of vinyl on the top row.
How to remove small pieces of vinyl siding.
Use the zip tool to release the buttlock at the top and bottom of the piece you want to remove.
Starting at one end of the damaged piece push the end of the zip siding removal tool up under the siding until you feel it hook the bottom lip.
First you nail up the new piece driving nails through the slots in the nail hem then you connect the buttlocks with the zip tool.