Here are a few tips on how to set a fence post so it won t rot.
How do you replace a rotted fence post.
Most of the time repairing or replacing fence posts is a hugely awkward difficult job.
When repairing a post remove the fencing and rails connected to it.
How to replace fence post anchors in concrete or fence post spikes without concrete.
Usually the existing wooden post has rotted at ground level because it has been concreted in by someone who did not take 5 minutes to trowel the top of the concrete to a slight dome allowing the rain water to run off.
Pour concrete so it extends a few inches above the grass.
Some have successfully used fence post anchors.
Here s a quick film showing you how you can replace a broken or rotten post using a repair spur.
If you have an old wood fence post that is completely rotted off and you are able to remove it along with all debris you could reuse the cement ball for a new post.
This way the post will not be sitting in.
Set the new fence post into the hole.
Before you do this you ll want to use some spare 2 x 4s to prop up the fence so it doesn t fall over.
Toss the soil and rotted wood onto a tarp for easy clean up.
Armed with the tips shown in this guide you can make a fence as good as new with minimal need to replace sections.
Thankfully the process is actually quite simple and knowing how to do it will allow you to replace anything from a single rotten beam to an entire fence.
Cut back any vegetation preventing you from accessing the rotted post.
Begin by removing any parts that get in the way of the repair.
Remove the rotted fence post and dig out any wood left in the fence post hole.
Here s a quick film showing you how you can replace a broken or rotten post using a repair spur.
Set a new fence post.
You can either remove the fencing with a pry bar or cut out the damaged section with a handsaw.
Wedge one end of a 2 x 4 under the top rail of the fence on either side of the post and push the other end into the ground.
Replacing a fence post may seem like a daunting task especially if concrete held the original post in place.
Taper the edges to drain water away from the wood post.